Tabla de contenido
Idiomas disponibles
Idiomas disponibles
NOTICE: Do not tighten adjusting screw with guard latch in open
position. Undetectable damage to guard or mounting hub may result.
MOUNTING
cu'rI'ING
WHEELS (FIG. 19)
1. Remove soft mount (E).
2. Install wheel backing flange, aligning flats on spindle (R) with flats
on backing flange (S).
3. Place the wheel on the backing flange, centering the wheel on the
backing flange pilot.
4. Install the clamp nut, ensuring that the wheel remains centered on
the backing flange.
5. Depress the spindle lock button and tighten clamp nut with
wrench.
6. Reverse the above procedure to remove the wheel.
FIG. 19
USING CUTTING WHEELS (FIG. 20)
,_,WARNING: Do not use edge grinding/cutting
wheels for surface
grinding applications because these wheels are not designed for side
pressures encountered with surface grinding. Wheel breakage and
injury may result.
1. Allow tool to reach full speed before touching tool to work
surface.
2. Apply minimum pressure to work surface,
FIG.20
allowing tool to operate at high speed.
3. Once you begin a cut, maintain the angle of
the cutting wheel to the work surface. This will
keep you from bending the wheel which could
result in wheel breakage and injury.
4. Remove the tool from work surface before
turning tool off. Allow the tool to stop rotating
before setting it down.
MAINTENANCE
WARNING:
To reduce
the risk of injury, turn
unit off
and disconnect
it from power
source before installing and
removing
accessories,
before
adjusting
or when
making
repairs. An accidental start-up can cause injury.
Cleaning
A WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
_ WARNING:
Never use solvents or other harsh chemicals
for
cleaning the non-metallic parts of the tool These chemicals may
weaken the plastic materials used in these parts.
Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool," never immerse any part of the tool into a liquid.
Accessories
/_ WARNING:
Since accessories,
other than those
offered by
DEWALT, have not been tested with this product,
use of such
accessories with this tool could be hazardous. To reduce the risk of
injury, only DEWALT recommended accessories should be used with
this product.
18
Tabla de contenido
