Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.With the guard l atch open, rotate t he FIG. 7
guardinto the desired working
position that provides maximum
protection totheuser asshown.
4.Close t heguard l atch tosecure t he
guard o nthegear c ase. You should
be unable to rotate theguard by
hand when thelatchisclosed. Do
notoperate t hegrinder witha loose
guard or the guard latchin open
position.
5.Toremove the guard, f ollowthe
procedure
above i nreverse order.
NOTE" T heguardis pre-adjusted
to
thediameter of thegear c asehubat
thefactory. If, aftera period of time,
theguard becomes loose, t ighten the
adjusting screw (J)withclamp in the
closed p osition.
NOTICE:
Do not tighten the adjusting
screw with the guard
latch in open
position. Undetectable
damage to the
guard or the mounting hub may result.
"J
Mounting
and Removing
Hubbed
Wheels
Hubbed wheels install directly on the 5/8"-11 threaded spindle.
1. Thread the wheel on the spindle by hand, seating the wheel
against the soft mount.
2. Depress the spindle lock button and use a wrench to tighten the
hub of the wheel.
3. Reverse the above procedure to remove the wheel.
Sanding
Flap
Discs
soft mount
445928-01
Type 27 guard
D284937 7"
D284939 9"
hubbed sanding
flap disc
soft mount
445928-01
Type 27 guard
D284937 7"
D284939 9"
backing flange
54339-00
non-hubbed sanding
flap disc
clamp nut
22191-00
NOTE: Wheel size must match guard size; i.e., a new 7" wheel may
not be used with a 9" guard. The bottom surface of wheel must be
inside the bend of the guard lip.
11
Tabla de contenido
