Operation; Automatic Measurement (By Programed Time Intervals); Manual Measurement; To Stop A Current Measurement - A&D TM-2430 Manual De Instrucciones

Operation

Automatic Measurement
Caution
Automatic measurement uses the internal clock and parameters of automatic
measurement. Refer to section "Parameters for the Display and Clock" and
"Selection for the automatic measurement" for setting these parameters.
Press and hold the
on display, when the patient stops the automatic measurement or detaches the cuff.
If the automatic measurement mode is running without a patient arm or resistance,
damage will occur to the cuff.
Starting or re-starting automatic measurement mode
Step 1 Confirm the parameters for automatic measurement. Refer to "Selection for
the automatic measurement".
Step 2 Press and hold the
displayed the recorder starts an automatic measurement based on the
internal clock and the parameters for automatic measurement.
Operation using mode II (Sleep mode)
Step 1 Press the
Step 2 Press the
Stopping or canceling automatic measurement
Step 1 When the
the automatic measurement mode and the "A" disappears. Conversly, by
pressing the

Manual Measurement

Step 1 Press the
results are displayed and stored in memory.

To stop a Current Measurement

Step 1 Press the
measurement at once and releases the air from the cuff.
Automatic Measurement
AUTO ON/OFF
key for approx. 3 seconds so as to turn off "A" symbol
AUTO ON/OFF
AUTO ON/OFF key turning off the "S" when the patient wakes up.
AUTO ON/OFF key turning on the "S" when the patient goes to bed.
AUTO ON/OFF key is pressed for about 3 seconds the recorder exits
key again the "A" will reappear.
AUTO ON/OFF
START STOP
key. The recorder starts a measurement at once. The
START STOP
key during measurement. The recorder will stop the
Page 24
key for about 3 seconds. When the "A" is
Operation