Description - Hilti TE 106 Manual De Instrucciones

Obligation signs
Wear eye Wear a hard
protection
en
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Volts

2. Description

2.1 Use of the product as directed
The power tool is an electrically-powered breaker with pneumatic hammering mechanism.
The power tool is designed for light chiseling on masonry and finishing work on concrete.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
The power tool is intended for professional use. The power tool may be operated, serviced and repaired
only by authorized, trained personnel. This personnel must be informed of any special hazards that may be
encountered.
The power tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel
or when used not as directed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new
construction. The power tool may be operated only when connected to a power supply providing a voltage and
frequency in compliance with the information given on its type identification plate.
Changes or modifications to the power tool are not permissible.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
2.2 Chucks
TE C (SDS-plus) chuck
TE T (SDS-Top) chuck
16
Printed: 07.07.2013 | Doc-Nr: PUB / 5070790 / 000 / 00
Wear ear
hat protection
Chiseling
Location of identification data on the power tool
The type designation can be found on the type iden-
tification plate and the serial number on the side of
the motor housing. Make a note of this data in your
operating instructions and always refer to it when
Wear
making an enquiry to your Hilti representative or
protective
service department.
gloves
Type:
Serial no.:
Chisel position
adjustment