Connecting The Unit To The Network - Air Techniques ScanX Intraoral View Instrucciones Para Montaje Y Uso

Installation
7.8 Connecting the unit to the
network
Purpose of the network connection
The network connection is used to exchange in-
formation or control signals between the unit
and a software installed on a computer, in order
EN
to, e g:
US
– Display parameters
– Select operating modes
– Indicate messages and error situations
– Change device settings
– Activate test functions
– Transmit data for archiving
– Provide documents concerning the devices
The unit can be connected to the network with
a network cable or via WLAN
For information on connection via WLAN,
see "81 Installing and configuring the
unit"
Combining devices safely
– Safety and essential performance features
are independent of the network The device
is designed appropriately for operation inde-
pendent of a network However, some of the
functions are not available in this case
– Faulty manual configuration can lead to signifi-
cant network problems The expert knowl-
edge of a network administrator is required for
configuration
– The data connection utilizes part of the
bandwidth of the network Interactions with
other medical devices cannot be completely
excluded Apply the IEC 80001-1 standard for
risk assessment
– The device is not suitable to be connected
directly to the public internet
Danger can arise when connecting appliances
to each other or to parts of systems (eg
through leakage currents)
Only connect appliances together when there
i
can be no danger to the operator or to the
patient
Only connect appliances when there can be
i
no environmental impairment through such in-
terconnection
If it is not clear from the appliance data sheets
i
that such connections can be safely made or
if you are in any doubt, always get a suitably
qualified person (eg the manufacturer) to ver-
ify that the setup is safe
26
OBJ_DOKU-0000003578-mehrere-011.indd 26
A template for the system manufacturer's
declaration in accordance with Article 12
of Directive 93/42/EEC can be found in
our download section at wwwduerrden-
talcom (document no 9000-461-264)
Only connect peripheral units (eg computer,
i
monitor, printer) that conform at least to the
requirements set out in IEC 60950-1
(EN 60950-1)
Connecting the unit via the network cable
Plug the enclosed network cable into the net-
i
work socket of the device
2151100018L40 1903V012
09.04.2019 10:51:15