Chip Extraction; Saw Blade Selection; Replacing The Saw Blade; Riving Knife / Splitter - Mafell KSP 85 Fc Manual De Instrucciones

4.2 Chip extraction

Connect the machine to a suitable external dust
extractor during all work generating a considerable
amount of dust. The air velocity must be at least 20
m/s (65.6 ft / sec.).
The internal diameter of hose connector 3 (Fig. 1) is
35 mm ( 1 3/8 in.).

4.3 Saw blade selection

Use a sharp tool to obtain a good cut quality and
select a tool from the following list according to
material and application:
For cuts along and across the grain in soft or
hard wood:
- TCT circular saw blade Ø 230 x 2.5 x 30 mm ( 9
1/16 x 3/32 in. x 30mm ), 24 teeth
For cuts especially along the grain in soft or hard
wood:
- TCT circular saw blade Ø 230 x 2.5 x 30 mm ( 9
1/16 x 3/32 in. x 30mm ), 12 teeth
For cuts especially across the grain in soft or
hard wood:
- TCT circular saw blade Ø 230 x 2.6 x 30 mm ( 9
1/16 x 7/64 in. x 30mm ), 56 teeth

4.4 Replacing the saw blade

Danger
Pull the power plug during all
service work.

Press the locking bolt 8 (Fig. 2).

Using the Allen-key 5 (brackets Fig. 1), unfasten
the flange screw 18 (Fig. 3) counter clockwise;
remove the screw as well as the front clamping
flange 12.

Now you can remove the saw blade after
opening the retractable saw guard 13.

The clamping flanges must be free of adhering
parts.

Pay attention to the sense of rotation when
inserting the saw blade.

Afterwards, mount the clamping flange, attach
the flange screw and tighten it by clockwise
turning.

In doing so, keep the locking bolt depressed.
Do not press the locking bolt 8 (Fig.
2) with the machine running! The
machine may get damaged.

4.5 Riving knife / splitter

Danger
Pull the power plug during all
service work.
The riving knife / splitter 15 (Fig. 3) prevents the saw
blade from jamming during longitudinal cutting. The
correct distance to the saw blade is shown in (Fig. 4).

For adjustment, unfasten the two cylinder-head
screws 16 (Fig. 3) with the Allen-key supplied
with the saw 5 (Fig. 1).

Adjust the riving knife / splitter by shifting it in its
longitudinal slit. Afterwards retighten the two
cylinder-head screws.
5

Operation

5.1 Initial operation

Personnel entrusted to work with the machine must
be made aware of the operating instructions, calling
particular attention
instructions".

5.2 Switching on and off


Switching on: First press the lock-off button 1
(Fig. 1) and then press the switch trigger 2.
The built-in electronic system ensures a jerk-free
acceleration when the machine is switched on. In
addition, this electronic system adjusts the motor
down in case of overload, i.e. the saw blade will stop.
Switch the machine off then. Then switch the
machine on again and continue sawing at a reduced
feed speed.

Switching off: To switch off, release the switch
trigger.
-19-
to the chapter "Safety