Initial Use - Beurer BM 77 Manual De Instrucciones

6. Initial use

Inserting the batteries
• Remove the battery compart-
ment lid on the rear of the
device.
• Insert four 1.5 V AAA (alkaline
type LR03) batteries. Make sure
that the batteries are inserted
the correct way round.
• Close the battery compartment
lid again carefully.
• All display elements are briefly
displayed, flashes in the
display. Set the date and time
as described below.
If the battery replacement symbol
played, you can no longer perform any measurements and
must replace all batteries. Once the batteries have been
removed from the device, the date and time must be set again.
Any saved measurements are retained.
Operation with the mains part
You can alternatively also operate this device with a mains part
(not included in delivery). However, before connecting the de-
vice with the mains part, please ensure that you have removed
the batteries from the device. During mains operation, there
must not be any batteries in the battery compartment, as this
could damage the device.
4 x 1,5V AAA (LR03)
is permanently dis-
29
• To avoid any potential damage, the device may only be op-
erated with a mains part that meets the specifications de-
scribed in the chapter "Technical specifications".
• Furthermore, the mains part must only be connected to the
mains voltage that is specified on the type plate.
• First, remove the protective cap of the mains part connector
– located on the rear of the device – and insert the mains part
into the connection intended for this purpose.
• Then insert the mains plug of the mains part into the mains
socket.
• After using the blood pressure monitor, unplug the mains part
from the mains socket first and then disconnect it from the
blood pressure monitor. As soon as you unplug the mains
part, the blood pressure monitor loses the date and time set-
ting but the saved measured values are retained.
Set the hour format, date, time and Bluetooth
It is essential to set the date and time. Otherwise, you will not
be able to save your measured values correctly with a date and
time and access them again later.
There are two different ways to access the menu from
which you can adjust the settings:
• Before initial use and after each time you replace the bat-
tery:
When inserting batteries into the device, you will be tak-
en to the relevant menu automatically.
• If the batteries have already been inserted:
With the device switched off, press and hold the START/
STOP button for approx. 5 seconds.
settings
®