Cal Spas Aqua SQ63 Manual Del Usaurio página 29

Adjusting The Proper Bromine Levels
1. After start up, decrease the filtration cycle to F-4
and monitor the bromine level until it is within the
recommended range.
2. Use bromine test strips to achieve a 3-5 ppm
recommended level.
Note: It can take several days for the bromine level
to stabilize because the fill water that was used
sometimes contains contaminants that need to be
neutralized, thereby using up the initial bromine that is
generated.
3. Once the desired level has been achieved, turn the
dial down until a maintenance setting is achieved.
4. The common maintenance setting for an average
bather load is #4.
Note: When changing the setting, use bromine test
strips to determine when you have reached the level
you want.
2007 Portable Spa Owner's Manual
LTR20071001, Rev. B
Water Quality Maintenance
Once A Week
1. Test spa water with bromine test strip.
2. Based on test strip readings:
• First, adjust alkalinity if necessary.
• Then, adjust pH if necessary.
• Increase / decrease bromine production with
dial if required.
3. Remove dirty filter from the spa and rinse off.
4. Place your clean, extra filter cartridge back into the
spa.
5. Add 2 oz of Cal Spas "Oxidizer Shock" to spa. Run
spa for 15 minutes
6. Vacuum debris from the bottom of your spa with
the "Spa Vacuum".
7. Replace cover.
Page 27