8005 And 9005 Electronic Control Operation; Initial Start-Up - Cal Spas Aqua SQ63 Manual Del Usaurio

Operating Your Spa

8005 and 9005 Electronic Control Operation

When first powered up, the
8005 and 9005 electronic
system will perform a self-
diagnostic check and then it
will automatically heat to and
maintain a temperature of
37.5˚C until you change the
set temperature as listed in
the "Temperature Adjustment"
section below.
These instructions will describe
features and options that your
particular spa may not be equipped with.

Initial Start-up

When your spa is first powered up, it displays some
configuration codes and then goes into priming mode
(Pr will appear on the display panel). This mode lasts
up to four minutes and then the spa begins to heat to
its pre -programmed temperature of 37.7˚C. You can
exit the priming mode early by pressing UP or DOWN
buttons.
Temperature Adjustment (26.0˚C - 40.0˚C)
The start-up temperature is set at 37.5˚C. The last
measured temperature is constantly displayed on
the control panel. Note that the last measured spa
temperature is displayed. The displayed temperature
will be updated when the pump has been running for at
least two minutes.
Press the UP or DOWN buttons once to display the
set temperature. Each time either button is pressed
again, the set temperature will increase or decrease
depending on which button is pressed. After three
seconds, the control panel will automatically display the
last measured spa temperature.
Time
When time hasn't been programmed, the TIME icon
flashes. To set the time, press the TIME button and
then the MODE/PROG button. Use the UP and DOWN
buttons to adjust time. See the next page for more
detailed instructions.
Standard, Economy, Sleep, and Standby
Modes
Mode/Prog: This button is used to switch between
standard, economy, and sleep modes.
1. Press MODE/PROG to enter mode programming.
Page 10
2. Press the DOWN button to cycle through to the
desired mode.
3. Press MODE/PROG to confirm selection.
Standard Mode: This is programmed to maintain
the desired temperature. Note that the last measured
spa temperature displayed is current only when the
pump has been running for at least two minutes. The
"STAND" icon will display until the mode is changed.
Economy Mode: Economy mode heats the spa to the
set temperature only during filter cycles. The "ECON"
icon will display until the mode is changed. Pressing
the JETS 1 button while in economy mode puts the
spa in standard-in-economy mode, which operates the
same as standard mode but reverts back to economy
mode automatically after one hour. During this
time, pressing the MODE/PROG button will revert to
economy mode immediately.
Sleep Mode: Sleep mode heats the spa to within 11˚C
of the set temperature only during filter cycles. The
"SLEEP" icon will display until the mode is changed.
Standby Mode: Pressing "Warm" or "Cool" then "Jets
2" will turn off all spa functions temporarily. This is
helpful when changing a filter. Pressing any button
resets the spa.
Jets 1 and Jets 2
Press the JETS 1 button once to turn pump 1 on or off
and to shift between low and high speeds if equipped.
If left running, the low speed turns off after two hours
and the high speed turns off after 15 minutes. On
non-circulation systems, the low speed of pump 1 runs
when the blower or any other pump is on. It may also
activate for at least two minutes every 30 minutes to
detect the spa temperature and then to heat to the set
temperature if needed, depending upon the mode.
When the low speed turns on automatically, it cannot
2007 Portable Spa Owner's Manual
LTR20071001, Rev. B