BH FITNESS G-245 Instrucciones De Montaje Y Utilización página 48

ELECTRONIC MONITOR.-
When the machine is switched on the
monitor will display U1 in the centre of
the screen. Select the user, between
U1-U4, using the ▲/▼keys and then
press ENTER.
To give you greater control over the
exercise, this
provides simultaneous read-outs of
speed/rpm, distance, exercise time,
calories burnt and pulse rate.
STARTING.-
To switch the monitor on first plug the
adapter (138 9V), supplied with the
machine, into the mains socket (220 V
– 240 V) and the jack on the adapter
into the socket at the bottom of the
machine.
The screen
automatically on the "U1" (User 1)
program as soon
exercising, To pass onto the exercise
screen, press the ENTER key and the
display screen will take you to the
program selection mode.
If at any time during exercise you
press the START/STOP button then
all of the unit's functions will stop.
Pressing the START/STOP button
again will restart the machine.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes.
Important:
components in special containers,
Fig.1.
electronic monitor
will switch
as you
Deposit electronic
English
MONITOR FUNCTIONS.-
This electronic unit has seven function
keys: RECOVERY, FAN ON/OFF,
START/STOP; RESET, ENTER; ▲;
▼. The centre of the screen will
simultaneously display the selected
program level. There are five windows
at the bottom of the display that
indicate
DISTANCE; WATTS/CALORIES and
PULSE RATE/THR.
This monitor also has 1 manual
program, 12 pre-set exertion level
programs; 1 user defined program and
4 Heart Rate Control programs.
With the monitor either stopped or
working
WATT/CAL windows give alternate
displays every 5 seconds.
on
STARTING THE FAN.-
To switch the fan on or off, press the
start
FAN ON/OFF key.
Whenever you finish your exercise,
make sure that the fan is switched off.
Pressing the RESET key will take you
back to the start. Holding the RESET
key down for 4 seconds will reset the
monitor allowing you to select a new
user by pressing the ▲/▼ and
ENTER keys.
CHANGING
WORK MODE TO ANOTHER.-
This monitor allows you to work in 4
different modes: Manual, Program,
User and Pulse (TARGET HR). In
order to pass from one mode to
another,
button to stop the monitor, then press
RESET and, with the help of the ▲/▼
buttons, select the desired mode.
9
the SPEED/RPM;
the SPEED/RPM
FROM
press the START/STOP
TIME;
and
ONE