Listening To The Fm Radio - Onkyo CR-N775D Serie Manual De Instrucciones

> Before Start > Part Names

Listening to the FM Radio

1
2
3
20
> Install > Initial Setup
Tuning Automatically
Perform the following procedure when the unit is on.
1. Repeatedly press INPUT 2/1 on the remote
controller to switch input to FM.
2. Repeatedly press ENTER (b) on the remote
controller so that "AUTO" appears on the display.
3. When you press TUNE 3/4 (a) on the remote
controller, automatic tuning starts, and searching
stops when a station is found. When tuned into an
FM station, is displayed. During stereo
reception "STEREO" is displayed and during
monaural reception "MONO" is displayed.
STEREO AUTO
FM
When FM broadcasts reception is poor: Perform the
procedure for "Tuning Manually" in the following
section. Note that if you tune manually, the reception
for FM broadcasts will be monaural rather than stereo,
irrespective of the sensitivity of the reception.
Tuning Manually
Perform the following procedure when the unit is on.
1. Repeatedly press INPUT 2/1 on the remote
controller to switch input to FM.
2. Repeatedly press ENTER (b) on the remote
controller to turn off "AUTO" on the display.
3. While pressing TUNE 3/4 (a) on the remote
controller, select the desired radio station.
0 The frequency changes by 1 step each time you
> Playback
Supplementary information | Advanced Setup | Others
press the button. The frequency changes
continuously if the button is held down and stops
when the button is released. Tune by looking at
the display.
0 After pressing skip (:/9) dial on the main
unit until the frequency display flashes, you can
turn the dial left or right to tune stations.
a
Asb
MHz
b