Idiomas disponibles
Idiomas disponibles
4. CONNECTION TO THE POWER SUPPLY OUTLET
The following models:
P134H
500/509/509E,
P134H
450/459,
P134HA
500/509/509E, P134HA 450/459, P134A 399/399E, P234H
450, P150H or P150HA
have a single-phase connection. Check that the plug is not
damaged or defective.
In case of doubt, do not connect the oven to the power
supply socket and contact Effeuno's technical service
department.
If you have purchased the following model:
Model P250H
can have two types of connection. For the single-phase
version, follow the instructions above; for the three-phase
version, the connection to the power mains and the
commissioning of the oven must be carried out by a
specialized
technician/installer,
according
to
the
regulations in force in the country of installation.
The figure on the right shows the three-phase 380V
connection with neutral for the P250H model only. Install
a power supply socket within the range of the oven cord.
Do not use extension cords and install a box suited to
contain the installation material.
The terminal strip is on the rear side of the oven.
CAUTION: The only model that can be converted to a three-phase oven is the P250H, none of the other models
can be modified from single-phase to three-phase operation.
The oven must be connected to the mains by means of a three-pole power cable with a neutral of adequate
length, with a yellow/green earthing line, at the end of which it is necessary to install a CEE socket in compliance
with the IEC 309-2 standard "Plugs, socket-outlets and couplers for industrial purposes" and suitable for the
power supply voltage and the rated current absorbed by the appliance, indicated in the wiring diagram and in
the "Technical characteristics" section (see the technical data plate).
Page 4 of 12
