What To Do If - Zanussi ZSF2430 Manual De Instrucciones

3
External cleaning
Clean the external surfaces of the appliance and control
panel with a damp soft cloth. Only use neutral detergents.
Do not use abrasive products, scouring pads or solvents
(acetone, trichloroethylene etc...).
Frost precautions
Caution! Do not install the appliance where the
temperature is below 0 °C. The manufacturer is not
responsible for damage because of frost.

What to do if...

The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the problem
yourself. If you cannot find a solution to the problem
yourself, contact the Service Force Centre.
Fault code and malfunction
• continuous flash of the start/cancel in-
dicator light
• 1 flash of the end indicator light
The dishwasher does not fill with water
• continuous flash of the start/cancel in-
dicator light
• 2 flashes of the end indicator light
The dishwasher will not drain
If not possible, empty the appliance and close the door.
Disconnect the water inlet hose and remove water from the
water inlet hose.
Long periods of non-operation
Do these steps when you do not use the appliance for a
long period:
1. Disconnect the mains plug from the mains socket.
2. Close the water tap.
3. Keep the door open to prevent unpleasant smells.
4. Keep the inner side of the appliance clean (filters es-
pecially).
Caution! Switch off the appliance before you do the
below suggested corrective actions.
Possible cause and solution
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is closed.
Open the water tap.
• The filter in the water inlet hose is blocked.
Clean the filter.
• The connection of the water inlet hose is not correct. The hose can be
kinked or squashed.
Make sure that the connection is correct.
• There is a blockage in the sink spigot.
Clean the sink spigot.
• The connection of the water drain hose is not correct. The hose can
be kinked or squashed.
Make sure that the connection is correct.
11