Idiomas disponibles
Idiomas disponibles
As drop arrester for this product, use only a combination of the Hilti retaining strap #2293133 and the Hilti
tool tether #2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
6
Operation
CAUTION
Risk of injury! Do not direct the laser beam toward persons.
▶ Never look directly into the source of the laser beam. In the event of direct eye contact, close your eyes
and move your head out of the path of the laser beam.
Observe the safety instructions and warnings in these operating instructions and on the product.
6.1
Switching the laser beams on
1. Set the selector switch to the
▶ The vertical laser lines are switched on.
2. Press the line mode button repeatedly until the desired line mode is set.
▶ The operating modes change in the following sequence and the sequence repeats itself: vertical lines,
vertical side line, horizontal line, vertical and horizontal lines.
6.2
Matching two points over distance by fine adjustment
1. Position the device with the lower plumbing beam centered on the reference cross on the ground.
2. Turn the knob for fine adjustment until the vertical laser beam is aligned with the second, remote control
point.
6.3
Setting the laser beam for the "Inclined line" function
1. Set the selector switch to the
2. Press the line mode button repeatedly until the desired line mode is set. → page 30
When the "Inclined line" function is active, the pendulum is locked and the laser is not leveled.
The laser beam(s) blink every 5 seconds.
6.4
Activating or deactivating laser receiver mode
The range of the laser receiver might be restricted on account of the design-related asymmetry of the
laser power and possible disruptive external light sources.
To optimize the range, work on a strong side of the line laser and avoid working in direct light. The
strong sides are the rear, where the battery is mounted, and the opposing front.
1. To activate the receiver mode, press the receiver mode button. The laser beam flashes five times as
confirmation.
2. Press the receiver mode button again to deactivate the receiver mode.
Receiver mode is deactivated when the tool is switched off.
6.5
Switching the laser beams off
1. Set the selector switch to the OFF position.
▶ The laser beam is switched off and the pendulum is locked.
2. The laser beam is switched off automatically when the battery is low.
30
English
position (ON / unlocked).
position (ON / locked).
2394965
*2394965*
