Zummo Z40 Manual De Usuario página 24

WARNING! The components of different squeezing Kits should not be mixed.
5. SERVICING MANUAL
•
We recommend disconnecting the machine from the power before starting any assembly,
disassembly or cleaning processes.
•
Do not wash the machine with direct jets of water and/or at high pressure.
•
The parts comprising the squeezing zone (cups, balls, squeezing tray, filter, cutting blade
and front cover), should be cleaned at least once a day following the cleaning instructions in
5.7 DISASSEMBLY AND CLEANING.
•
The juicer produces citrus juice with pH of 4.5, and it is therefore not considered to be a
potentially hazardous food.
5.1. GETTING STARTED
•
Depending on the size of fruit to be squeezed, the most appropriate squeezing kit for the
size of the fruit should be fitted in order to ensure the best possible performance and reduce
the possibility of incidents. See 4. ACCESSORIES.
•
Fit all the squeezing system components, feeder and protections or guards to the machine
in the right position. See 5.7 DISASSEMBLY AND CLEANING.
•
Juice service:
•
ADAPT self-service tray: The machine features two operating modes, see 5.2
PROGRAMMING to prepare the machine for the required operating mode:
- Manual Mode (controlled using the display buttons): Select the number of fruits to
be squeezed on the display. When pressing ON, the machine will squeeze the
selected number of fruits.
To stop the squeezing process, press STOP. The display will temporarily show a
Clock and Stop until it completes the current squeezing cycle and the machine
comes to a stop. Afterwards, the display will show the previously selected number
of cycles.
- Self-service mode: When opening the tap, the machine will start working.
To stop the squeezing process, close the tap. The display will temporarily show a
Clock and Stop until it completes the current squeezing cycle and the machine
comes to a stop. The display will then show a fruit, indicating that it is ready to start
squeezing.
•
SERVICE tank:
- Remove the two front screws on the front of the machine base and fit the tank
support using the same screws.
- By using this accessory you will only be able to control squeezing in Manual Mode
(control via the display buttons). When the tap is opened, the juicer will serve the
amount previously stored in the tank, but it will not start operating.
5.2. PROGRAMMING
The machine is delivered from the factory in mode 1001 Auto-programming by default. In this
mode the machine returns to the Manual Mode (control via the display buttons) each time it is
switched off. There are two available options to configure the operating mode:
1. Manual programming: To permanently configure the operating mode, the machine needs to
be disconnected at the power switch. When the machine is switched off, press STOP and
24