Location And Function Of Parts And Controls; Front Panel - Sony YS-SX509P Manual De Instrucciones

Location and Function of Parts and Controls

Location and Function of Parts and Controls

Front Panel

2
1
1 STANDBY indicator
When you connect the cable (supplied) to the power
outlet, the STANDBY indicator (red) is turned on
indicating that the multiplexer is in the standby mode.
2 ON/STANDBY button and indicator
Pressing the ON/STANDBY button turns on the power
and the indicator (green). Pressing the button again
turns off the power and the ON/STANDBY indicator,
and the STANDBY indicator (red) is turned on.
Note
In order to keep the unit internal temperature low, a
fan is provided on the side of the unit. If the fan does
not operate properly, the ON/STANDBY indicator will
flash to indicate a problem. Unplug the unit from the
power supply and check to make sure nothing is
obstructing the fan. If after the power is restored to the
unit, the ON/STANDBY indicator still flashes, do not
use the unit and consult your dealer.
3 INPUT SELECTOR button and indicator
Pressing INPUT SELECTOR turns on the indicator on
the button, and displays the image on Monitor; the
image is selected from the images of the cameras
connected to the CAMERA IN connector (1 – 9). The
indicator for the camera (where an alarm has been
activated) flashes.
8
(GB)
3 4 5
ql
4 MULTI button and indicator
Pressing this button displays the Multi-display (9
divisions) screen.
5 QUAD button and indicator
Pressing this button switches the quad divisions screen
from subscreens 1-4, 5-8 and 9.
6 MENU button
Pressing this button shows the menu screen. Every
time you press this button the menu screen switches.
7 NEXT button
Use this button to switch the submenus in the
following menus:
– CAMERA SET menu
– DISPLAY SET menu
– ALARM DATA menu
8 V, v, b, B buttons
Use these buttons to move the cursor in the menus.
67 8
qk qj qh qg qf
Pressing the NEXT button in the CAMERA SET
menu switches to the SENSOR SET submenu.
Pressing the NEXT button in the DISPLAY SET
menu switches to the CLOCK POSITION SET
submenu.
Pressing the NEXT button in the ALARM DATA
menu sequentially displays the recorded alarm data.
9 0
qa
qd qs