Basic Operations; Mode Switching - Sony YS-SX509P Manual De Instrucciones

Basic Operations

Mode Switching

When the VCR, LIVE or MENU button is pressed the
corresponding mode screen is displayed as shown
below.
The image displayed on-screen will depend on the
mode set, field switcher or multi-viewer mode (see
VCR playback mode
Live Picture Mode (see pages 21 (GB),
27 (GB))
When the LIVE button is pressed, the live (direct)
picture from the cameras connected to the camera
input terminals (1 – 9) on the unit rear panel, will be
displayed on monitor.
Notes
• The unit will automatically start in the live picture or
VCR playback display mode (9, 4 divisions split
screen, full screen or sequential display) last selected.
Therefore, when a mode is selected, the display mode
will remain the same.
• If a camera is not connected at one of the input
terminals, "NO VIDEO" will be displayed on the
monitor screen.
pages 20 (GB) or 46 (GB)). When the power is
restored after having already used the unit, the unit
will restart in the modes selected before the unit was
turned off.
LIVE picture mode
VCR Playback Mode (see pages 22 (GB),
32 (GB))
Start playback on the VCR. If the video signal is
correctly recorded, the VCR playback image will be
displayed on monitor when the VCR button is pressed.
Notes
• If playing back a tape not recorded through this unit,
"NO ID" will be displayed on the monitor screen.
• In live picture mode and VCR playback mode there
may be a slight vertical roll of the picture.
Menu mode
17
(GB)