Rear Panel - Sony YS-SX509P Manual De Instrucciones

Location and Function of Parts and Controls

Rear Panel

1
2
1 CAMERA IN (Video camera signal input)
connector (1 – 9)
Inputs signals from an external camera.
2 CAMERA OUT (Video camera signal output)
connector (1 – 9)
Each camera signal is output directly at these connec-
tors.
3 VCR IN (VCR input) connector
Inputs video signals from an external VCR.
4 VCR OUT (VCR output) connector
Outputs video signals to an external VCR.
5 MONITOR (Monitor output) connector
Outputs video signals to an external monitor.
6 RS-485 connector (A/B connector)
This connector connects the RS-485 serial control bus
with an RJ-11 cable. This terminal connects other
devices controlled by the controller or the same bus.
For details, see pages 14 (GB), 60 (GB).
Cautions
• Do not connect to a phone line.
• Only up to two RS-485 control ports can be used.
• Do not use all of the RS-485 control ports.
10
(GB)
3 4 5 6
7 RS-232C connector
To control this unit using a personal computer, connect
the computer serial terminal to this connector using a
9-pin D-SUB cable (not supplied).
For details, see pages 15 (GB), 60 (GB).
8 Interface DIP switches (10 BIT)
These DIP switches set the address for serial control.
These DIP switches switch between the RS-485
control and the RS-232C control; they also set the RS-
485 control bus termination.
For details, see page 60 (GB).
9 CONTROL terminal
Inputs external remote control signals.
For details, see pages 14 (GB), 15 (GB), 16 (GB).
q; Power cord holder
Using the supplied tie, attach the power cord to the
holder as illustrated.
qd
qs qa
7 9 0
8