Philips AUT1211 Manual página 11

2. Take out the �lter cartridges by turning them counterclockwise. Mark the replacement date of
• The system and installation shall comply with applicable local regulations.
each �lter, according to the �lter lifetime information in Chapter VI. Re-insert all the �lters back in
• This product cannot be disposed of with other domestic waste products.
the system.
At the end of the product's service life, it should be returned to the place of purchase, or at a local
recycling center, indicating that it contains electric and electronic components. The appropriate
collection and treatment of the product, which no longer are to be used, contributes to the
preservation of natural resources and avoids any potential public health risks.
1
2
3
3. Turn on the faucet. Wipe all the joints and connections with tissue to check if there is leakage. If
the tissue stays dry, it means the system is installed properly. Let the water run for 10minutes to
�ush the �lter cartridges. Now the system is ready to use.
Note: The water can be collected to water �owers or plants.
VI. Maintenance
1. Routine maintenance
• Organic solvent such as gasoline shall not be used for wiping the housing of the device. If cleaning is
required, please gently wipe the surface of the product with a wet cloth.
• If the system is not used for more than 2 days, let water run for at least 10 minutes to �ush the �lters
and the system.
• If the system will not be used for an extended period (more than 3 days), take out the �lter
cartridges, seal them with plastic wraps, and store them in the refrigerator (not in the freezer).
Before using it again, let water run for at least 10 minutes to �ush the �lters and the system.
Start Date:
Replace Date:
11
/ /
/ /