Capacity Display; Settings; Adjusting The Cutting Depth - Festool TSC 55 REB Manual De Instrucciones

Capacity display

The capacity display [1-12] automatically displays
the charge state of the battery pack [1-6] when the
ON/OFF switch is actuated:
70 - 100 %
40 - 70 %
15 - 40 %
< 15 %
Recommendation: Charge bat-
tery pack before further use.
WARNING
Risk of injury, electric shock

Always disconnect the battery packs from the
machine before performing any type of work on
the machine!
Electronics
Smooth start-up
The electronically controlled smooth start-up en-
sures that the machine starts up jolt-free.
Constant speed
The motor speed remains constant through elec-
tronic control to ensure a uniform cutting speed
even when under load.
Speed control
You can regulate the speed steplessly within the
speed range using the adjusting wheel [1-10] (see
Technical data). This enables you to optimise the
cutting speed to suit the surface (see table 1).
Current limiting
Current limiting prevents excessive current con-
sumption under extreme overload, which can lead

Settings

to a decrease in the motor speed. The motor imme-
diately restarts after the load is removed.
Brake
The TSC 55 REB is fitted with an electronic brake.
When the saw is switched off, the saw blade slows
to a stop electronically within approx. 2 seconds.
Temperature cut-out
When exceeding a certain engine temperature lev-
el, the machine power supply and speed are
capped. The power tool continues operating at re-
duced power to allow the ventilator to cool the mo-
tor rapidly. The power tool resumes to full perfor-
mance automatically once the motor has cooled
sufficiently.

Adjusting the cutting depth

The cutting depth can be adjusted to between 0 – 55
mm on the cutting depth stop [3-1]:
The sawing unit can now be pressed down to the set
cutting depth.
Cutting depth without guide rails
max. 55 mm
Cutting depth with guide rail FS
+FS
max. 51 mm
LED red – lit continuously: battery,
electronics or motor temperature
is outside the permitted range.
LED red – flashing: indicates a
general fault, e.g. incomplete
contact, short circuit, battery
pack faulty, etc.
13