1
3
5
Troubles
Machine doesn't work
No water on the blade
Motor stops during cutting (thermal
protection is triggered due to high
temperature rises of the motor)
16. CUSTOMER SERVICE
For customer services, please contact the following
address:
Carat Nederland B.V.
Nikkelstraat 18, 4823 AB Breda, The Netherlands.
www.carat-tools.nl/.com/.be/.dk
2
Before performing any maintenance, make sure the
machine is isolated from any electrical supply.
To ensure a long-term quality, make the following
maintenance actions every time after using the machine:
• Inspect visually the whole machine.
• Clean flange and blade fixing devices.
• Clean Motor (housing + cooling fans), water tray, water
4
• Make sure all bolts and screws are tighten.
Before using the machine, make sure all above actions
have been done.
Before performing any reparation, make sure the machine
6
is isolated from any electrical supply.
performed only by a qualified electrician.
Possible causes
No electricity
Defective cable
Defective switch
Defective motor
Not enough water in the water tray
Closed water tap
Clogged water system
Defective water pump
Water pump is off
Wrong blade for the application
Defective blade
Worn blade
Cutting advance too fast
Undue pressure on the blade
In order to avoid problem, make sure to give the following
information:
• Machine article number
• Machine serial number
• Parts article number, denomination and quantity needed
• Delivery address
14 MAINTENANCE
pump, water pump filter, water hoses and nozzles, table
guiding rails, table wheels.
15 TROUBLE-SHOOTING GUIDE
Attention: Any works dealing with the electrical
system or supply of the machine should be
Resolutions
Check the supply cable
Make sure it is plug correctly
Change the cable
Change the switch
Refill with clean water
Open the water tap
Clean the water system
Clean or change the water pump
Check electric circuit
Change the blade
Change the blade
Change the blade
Cut slowly
Cut slowly
19
