9
TOOL ASSEMBLY
To mount a new blade, always do the following instruc-
tions:
• Switch off the machine and unplug the supply cable. (1)
• Loose the screw which on the back of blade guard. And
rotate the blade guard. (2)
• Loose the left threaded hexagonal nut on the motor
shaft and remove the outer flange and the tool. (3)
• Clean the tool shaft and flanges and inspect for wear. (4)
• Mount the new blade. Make sure the tool rotation is
correct and the bore corresponds to the shaft diameter.
mount back the outer flange and tighten the left thread-
ed hexagonal nut on the motor shaft (5)
• Rotate the blade guard back in place.
Tighten the screw. (6)
1
3
5
10 ELECTRICAL CONNECTIONS
Before connecting the machine to a power supply, make
sure:
• •
The voltage/phase supply corresponds to the infor-
mation indicated on the motor plate and machine plate.
• Available power supply must have ground connection in
conformity with safety regulations.
• The size of the electric cable of the extended lead is
sufficient (H07RNF 3x2.5mm2 up to 50m for 230V).
16
Before starting pay extreme care and attention:
• Make sure the blade guard is closed
• Make sure the blade is not touching the table at any
• Fill the water tray with clean water and make sure the
• Material weight to be put on the table should be less
• Lock the legs when the machine is on.
To start the machine, open the cover of pump on-off
2
switch, press " I " to switch on the pump, open the cover
of the switch and press the green button.
To stop the machine, press on the red button or directly
on the emergency switch to stop the machine.
After starting the machine check immediately the follow-
ing conditions are:
• The water is flowing freely, abundant and is delivered to
4
• The water nozzles and hoses are not clogged.
If one of these conditions is not correct, stop immediately
the machine!
The motor is equipped with a thermal protection to
prevent high temperature rises, if the thermal protection
triggers, wait until the motor has cooled down before
6
starting the machine again.
13.1 FIXED DEPTH CUTTING
In fixed depth cutting, the cutting head is locked in a fixed
position.
To do fixed depth cutting, please follow this procedure:
• Switch off the machine and make sure the blade is not
• Loosen the adjusting handle. (2)
• Adjust the cutting head to the desired position. (3)
• Adjust the depth stop and tighten the counter nut to fix
• Make sure the blade is not touching the table at any
• Tighten strongly the adjusting handle and make sure the
• Put material on the table, adjust the position using the
• Start the machine. (7)
11 BEFORE STARTING THE MACHINE
position of the table and cutting head
water pump in completely immersed in the water. The
water pump must not run without water, refill the water
tray with clean water if necessary.
than 10 kg and having dimensions smaller than the
maximum cutting length and depth.
12 STARTING THE MACHINE
both sides of the blade.
13 CUTTING METHODS
rotating. (1)
it well. (4)
position of the table.
cutting head is well fixed and cannot move. (5)
guide-a-cut. (6)
