Carat X-COUP BEX3500000 Instrucciones página 17

• Put your left hand on the table pushing handle. Put your
right hand on the cutting head handle. Your right hand
should be ready to push the emergency stop in case of
any unexpected problem. (8)
• Push the table slowly and without undue pressure
towards the rotating blade. (9)
1
3
5
7
9
13.2 FREE DEPTH CUTTING FOR MULTIPLE
In free depth cutting, the cutting head is not locked in
a fixed position. This cutting method enables multiple
steps cutting which consists of moving the table back and
forth with the material to be cut under the rotating blade.
For hard material, it is recommended to use this cutting
method (e.g. by doing many shallow cuts).
2
To do free depth cutting, please follow this procedure:
• Switch off the machine and make sure the blade is not
• Loosen the adjusting handle (2)
• Adjust the depth stop and tighten the counter nut to
• Make sure the blade is not touching the table at any
4
• Put material on the table, adjust the position using the
• Start the machine (6)
• Put your left hand on the table pushing handle. Put your
• Push the table slowly and without undue pressure
6
• Use your right hand to adjust the depth while cutting,
8
STEPS CUTTING
rotating. (1)
fix it well. (3)
position of the table when the cutting head is at the
lowest position. (4)
guide-a-cut. (5)
right hand on the cutting head handle. Your right hand
should be ready to push the emergency stop in case of
any unexpected problem. (7)
towards the rotating blade. (8)
Use your left one to slide the table back and forth. (9)
1
3
5
2
4
6
17
loading