7
9
13.3 45° BEVEL CUTS:
The X-COUP enables to make fixed or multiple steps 45°
bevel cuts.
To do 45° bevel cuts, please follow this procedure:
• Switch off the machine and make sure the blade is not
rotating. (1)
• Put the table at the front of the machine to clear the
space for the pivoting of the cutting head. (2)
• Loosen the big nut at the back of the cutting head. (3)
• Rotate the cutting head until it stops at 45°. (4)
• Tighten well the big nut at the back of the cutting head.
(5)
• Loosen the adjusting handle. (6)
• Adjust the depth stop and tighten the counter nut to fix it
well. (7)
• Make sure the blade is not touching the table at any
position of the table when the cutting head is at the
lowest position. (8)
• Put material on the table, adjust the position using the
guide-a-cut.
• Start the machine. (9)
• Push the table slowly and without undue pressure
towards the rotating blade.
1
18
8
To put the cutting head back in the normal position,
please follow this procedure:
• Switch off the machine and make sure the blade is not
• Put the table at the front of the machine to clear the
2
• Loosen the big nut at the back of the cutting head. (3)
• Rotate the cutting head until it stops at 0°. (4)
• Tighten well the big nut at the back and use your hand to
• Make sure the blade is not touching the table at any
3
5
7
9
rotating. (1)
space for the pivoting of the cutting head. (2)
maintain the position of the cutting head at 0° (because
the tighten torque could slightly modify the angle
possible of the cutting head!). (5)
position of the table when the cutting head is at the
lowest position. (6)
4
6
8
