CASO DESIGN CM 1000 Manual De Usuario página 55

Attention
► If dampness penetrates into the device, this can damage the electronic components.
Please ensure that no liquid can enter the interior of the device through the ventilation
slots.
► Do not use any aggressive or abrasive cleaning agents or solvents.
► Do not scrape off stubborn dirt with hard items.
► Because of the hazards involved in repair or maintenance work for which the radiation
safety cover must be removed, any such work may only be carried out by a skilled and
qualified specialist.
20.2 Cleaning
Cooking chamber and inside of door

Keep the cooking chamber of the oven clean. Wipe off any spattered or spilt food from the
walls of the cooking chamber with a damp cloth. If the oven is excessively dirty, you can
use a mild cleaning agent.
Wipe the door, window and the door gaskets with a damp cloth, to remove any spatters
and spilt food. Residues on the door gasket can mean that the door does not close
properly any more, which will cause the microwaves to escape.
Wipe off any steam, which has settled on the oven door, with a soft cloth. This may be the
case if the device is used in an extremely damp environment and is normal.
After cleaning the interior space, leave the oven door open until the interior of the device is
completely dry.
Cleaning hint – If there are cooked food residues stuck to the inside walls of the oven,
there is an easy way to clean these: Place half a lemon into bowl, add 300 ml water and
microwave this for 10 minutes at full power. Then simply wipe the inside of the appliance
clean with a soft and dry cloth.
Front of device and operating panel

Clean the front of the device and the operating panel with a soft, slightly damp cloth.
Please bear in mind that the operating elements do not get wet. Use a soft, damp cloth for
cleaning.
► Leave the oven door open to prevent the device from being re-started accidentally.
► Make sure that no water gets into the ventilation slots.
► After cleaning, you can use a dry, soft cloth to dry and polish the surface.
 Exterior housing
Clean the exterior surfaces of the device with a damp cloth.
-Base plate

Wipe the bottom of the device with a mild cleaning agent.
Please note
55