Idiomas disponibles
Idiomas disponibles
PLAYA - USE AND MAINTENANCE
DISPLAYED
MESSAGE
FLO
FLC
no alarm, but
the pool warms
slightly
no alarm, but
the pool warms
slightly
50
ACTIONS TAKEN
ITEM THAT
FROM THE
GENERATED THE
CONTROL SYSTEM
filter pump
the flow switch
turned off,
has detected
heater switched
insufficient
off if turned on
flow
the flow switch
detects the
if turned on,
flow even with
heater is
the filtration
switched off
pump turned
off
a LED flashes in
the lower right
on the display
when the heater
is in operation.
If the LED is
off, despite the
the flow
set temperature
switch is in an
is higher than
intermediate
water, it means
stage on / off
that we are in
a transitional
phase of pre-
clogging and
the heater was
turned off
a LED flashes
in the lower
--
right on the
display
POSSIBLE
CAUSES
ALARM
clogging of the
suction circuit
(prefilter
basket clogged,
clogged filter,
any foreign
body in the
pump impeller)
flow switch
blocked or
defective
semi-clogged
filter
lack of
isotherm
cover, setting
the filtration
cycles (the
heater turns on
only when the
filter pump is
running)
RECOVERY MODE
after removing the
cause, the alarm is
reset by pressing
the button "Filter
pump"
and then the
"hand" button
if, prior to the
alarm, the heater
was turned on,
the reset is active
again after 3
minutes.
Replacement of the
switch, the alarm
is reset by pressing
the on-off button
Clean the filter
use the isotherm
cover, the filter
pump has to
operate 24 hours
