Idiomas disponibles
Idiomas disponibles
Range Installation
Important
Note: Door removal is not a requirement for
installation of the range, but is an added convenience.
Refer to the Use and Care Guide for oven door removal
instructions.
Standard Installation
The range cooktop overlaps the countertop
at the
sides and the range rests on the floor. The cooktop
is 31 1/2" (81 cm) wide.
Install base cabinets
30" (76.2 cm) apart. Make
sure they are plumb
and level before
attaching
cooktop.
Shave raised countertop
edge to clear 31
1/2" (81 cm) wide range top rim.
Install cabinet doors 31 " (78.7 cm) min. apart so as
not to interfere with range door opening.
Cutout countertop exactly as shown on page 1.
Make sure the four leveling legs (front and rear) are
setup higher than the height of the cabinet (shown
on page 3).
Install
the anti-tip
bracket
at this
point
before
placing
the
range
at its final
position.
Follow the installation
instructions
on
page
13 or on the anti-tip
bracket
template
supplied with the range.
To provide an optimum
installation, the top surface
of the countertop
must be level and flat (lie on the
same plane) around the 3 sides that are adjacent to
range cooktop. Proper adjustments to make the top
flat
should
be made
or gaps
between
the
countertop
and the range cooktop may occur.
Position range in front of the cabinet opening.
Make sure that
the glass which
overhangs
the
countertop
clears the countertop.
If necessary, raise
the unit by lowering the leveling legs.
Level the range
(see section 8). The floor where
the range is to be installed must be level. Follow the
instructions under "Leveling the Range".
Slide the range into the cutout opening.
If Accessories
Needed
Installation
For 29" Existing
Cutout
Wide
Opening
1.
You must replace the actual side trims by new
and smaller side trims. These new side trims can
be ordered through a Service Center.
2.
Follow instructions supplied with your new side
trims to replace the actual side trims with the new
ones.
3.
Check if the countertop
is prepared for 29" cutout
wide opening in "Countertop
Preparation"
section (see page 7).
4.
Install range as in the "Installation
without
side
panels" section.
Installation
With Backguard
The cutout depth of (21 3/4" (55.2 cm)Min., 22 1/8"
(56.2cm) Max.) needs to be increased to 24" (61 cm)
when installing a backguard.
Installation
With End Panel
A End Panel kit can be ordered through a Service
Center.
Installation
With Side Panels
A Side Panels kit can be ordered through a Service
Center.
Install cabinet doors 31 " (78.7 cm) min. apart so as
not to interfere with range door opening.
To reduce the risk of damaging your
appliance,
do not handle or manipulate
it by the
ceramic glass. Manipulate with care.
10
