Kenmore 79073433310 Instrucciones De Instalación

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE
INSTRUCTIONS FOR FUTURE REFERENCE.
Tip Over Hazard
• A child or adult can tip the range
and be killed.
• Verify the anti-tip device has been
installed to floor or wall.
• Ensure the anti-tip device is re-engaged when the
range is moved to floor or wall.
• Do not operate the range without the anti-tip device in
place and engaged.
• Failure to follow these instructions can result in death
or serious burns to children and adults.
Range [_..
leveling leg _-_ i'_. _
_. _. Anti-Tip
j_ bracket
To check if the anti-tip bracket is installed properly,
use both arms and grasp the rear edge of range back.
Carefully attempt to tilt range forward. When properly
installed, the range should not tilt forward.
Refer to the anti-tip bracket installation instructions
supplied with your range for proper installation.
if the information in this manual
is not followed exactly, afire or explosion may
result causing property damage, personal
injury or death.
FOR YOUR SAFETY:
m Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance,
WHAT TO DO IF YOU SMELL GAS:
, Do not try to light any appliance.
, Do not touch any electrical switch; do not
use any phone in your building.
, immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.
, if you cannot reach yourgas supplier, call
the fire department.
= installation and service must be performed
by a qualified installer, service agency or
the gas supplier.
CERTIFIED
Refer to your serial plate for applicable agency
certifications
Provide proper fuel type
Before proceeding: Your range is factory preset to oper-
ate on natural gas. If L.P. conversion is needed, contact
your local L.P. Gas provider for assistance.
The L.P. conversion kit may be located on the lower rear
back panel of the range. If no L.P. kit is provided, contact
your product dealer to obtain the correct L.P. conversion
kit.
important notes to the installer
• Read all instructions contained in these installation
instructions before installing range.
• Remove all packing material from the oven
compartments before connecting the gas and electrical
supply to the range.
• Observe all governing codes and ordinances.
• Be sure to leave these instructions with the consumer.
important notes to the consumer
• Keep these instructions with your Use & Care Guide
for future reference.
• Be sure your range is installed and grounded properly
by a qualified installer or service technician.
Special instructions for a_j31iances installed in the State of
Massachusetts:
This appliance can only be installed in the State of
Massachusetts by a Massachusetts licensed plumber or
gas fitter. When using a flexible gas connector, it must
not exceed 3 feet (36 inches) in length. A "T" handle type
manual gas valve must be installed in the gas supply line
to this appliance.
1 p/n 316903000 Rev B (1210)