SICK WTM10L Instrucciones De Uso página 60

OPERATING INSTRUCTIONS
6.4.4 Output configuration
6.4.5 Restoring to factory default settings
en
6.4.6 Configuration via IO-Link
7 Troubleshooting
60 O P E R A T I N G I N S T R U C T I O N S | WTM10L
Tap the desired operating mode. Repeat this process for each output as needed.
M O D E
Figure 22: Display output function navigation
The sensor offers the function to restore the factory default settings.
Figure 23: Factory configurations
In addition to manual setting the parameters on the device, the sensor can also be
configured via IO-Link.
Configuration via IO-Link can be performed in two ways:
• Configuration via the SiLink box (required software: SOPAS ET from SICK)
To do this, connect the sensor to a computer via USB using the SiLink box.
• Configuration via an IO-Link Master (PLC), e.g. SIG350
You can quickly and easily test and parameterize the connected products using the
SOPAS ET program (SICK Engineering Tool with graphic user navigation and convenient
visualization).
Details on configuration can be found in the detailed IO-Link description:
Information: Photoelectric sensors, SICK Smart Sensors /
The Troubleshooting table indicates measures to be taken if the sensor stops working.
Q1
LO
DO
Q2
454
mm
164 mm
PNP
NPN
Push/
Pull
Technical
IO-Link.
9382969/2024-02-23 | SICK
Subject to change without notice