SICK WTM10L Instrucciones De Uso página 50

OPERATING INSTRUCTIONS
5.4 Integration of the sensor in IO-Link mode
6 Commissioning
6.1 Videos
en
6.2 Alignment
50 O P E R A T I N G I N S T R U C T I O N S | WTM10L
To operate the product in IO-Link mode, it must be connected to a suitable IO-Link
Master. This is used for further integration into the control system.
NOTE
The cable length between the IO-Link Master and IO-Link device: maximum 20 m.
Details on integration can be found in the detailed IO-Link description:
mation: Photoelectric sensors, SICK Smart Sensors /
NOTE
After successful connection of the product to the IO-Link Master, the green (Power) LED
flashes to indicate a functioning IO-Link communication between the master and device.
The following video show individual steps for commissioning:
Table 6: Videoübersicht
Commissioning of the WTM10L senosr
Alignment with background suppression:
Align the sensor with the object. Select the position so that the red emitted light beam
hits the center of the object. You must ensure that the optical opening (front screen) of
the sensor is completely clear [see
Figure 8: Alignment
Alignment with foreground suppression:
Align the sensor with the background. You must ensure that the optical opening
(front screen) of the sensor is completely clear
IO-Link.
https://video.sick.com/media/t/0_538a7d0l?
st=70
figure 8].
figure 9].
Technical Infor‐
9382969/2024-02-23 | SICK
Subject to change without notice