Idiomas disponibles
Idiomas disponibles
30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with Sealed Top Burners)
To avoid breakage: Do NOT handle or manipulate
the unit by the cooktop.
&
The countertop around the cut-out should be flat and leveled (see
hatched area on illustration 1).
Before installing the unit, measure the heights of the two (2) cabinet
&
sides (H1-4), front and back (see illustration 1) from the floor to the top
of the counter.
Level the range using the
Shave
1 2" Max.
(3.8 cm Max.)
two (2) front leveling legs
Raised
and the two (2) adjustable
Edge
leveling wheel, so that the — | to Clear
height from the floor to
Space for a
the underside of the metal
| 31%" (81 cm)
flange is greater than the
Wide Cooktop.
tallest cabinet measurement
by at least 1/16" (see
illustration 2).
Remove and discard the two rear leveling legs, they are only in place to
solidify the unit for the transport.
&
Slide the unit into the cabinet. Make sure the center of the unit is aligned
lllustration 1
with the center of the cabinet cut-out.
Remove the protective channels on each side of the cooktop (if provided).4
The metal flange under each side of the cooktop MUST be placed over
the cabinet countertop for proper unit support.
The cooktop should
NOT rest directly on the countertop (see illustration 2) or else it could
\
cause damage to the cooktop voiding the warranty. Level the unit if
8
Flange
needed.
:
oo
To successfully
install the
range, the initial
level height
from floor to
underside of
cooktop frame
should be at
least 1/16"
taller than
cabinet sides
as measured in
step 2.
supported by the two front leveling legs and the
two adjustable leveling wheels and NOT by the
cooktop.
oO
After the installation, MAKE
SURE that the unit is
Ve
Illustration 2
