Idiomas disponibles
Idiomas disponibles
30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with Sealed Top Burners)
ED
Position range in front of the cabinet opening.
Make sure that the underside of the cooktop
clears the countertop. If necessary, raise the unit
by lowering the front leveling legs and the back
leveling wheels.
Level the range (see section 9). The floor where
the range is to be installed must be level. Follow
the instructions under "Leveling the Range".
Slide the range into the cutout opening.
Wielareisa
if Accessories Needed :
installation With Backguard
The cutout depth of (21 3/4" (55.2 cm)Min., 22 1/8"
(56.2cm) Max.) needs to be increased to 24" (61 cm)
when installing a backquard.
installation With End Panel
A End Panel kit can be ordered through a Service
Center.
Installation With Side Panels
A Side Panels kit can be ordered through a Service
Center.
Install cabinet doors 32" (81.3 cm) min. apart so as
not to interfere with range door opening.
3
Leveling the Range
Models Equipped with Leveling Device
Level the range after installation in the cutout
opening.
1.
Open the range drawer. The leveling screws control
the height of the rear leg.
2.
Adjust the appliance legs and wheels as follows until
the underside of the cooktop surface is sitting level
on the countertop (Figure 7).
a. To adjust the front legs, use a wrench on
the leg base and turn clockwise to lower or
counterclockwise to raise.
b.Remove the rear legs using a wrench on the leg
base and turn counterclockwise until the legs are
removed from the unit. You can discard those
legs, they are only in place to solidify the unit for
the transport.
c. To adjust the rear wheels, use a ratchet or
a nutdriver and turn the leveling screws
counterclockwise to lower or clockwise to raise.
3.
Check if the range is level by installing an oven rack
in the center of the oven and placing a level on the
rack (Figure 8).
4.
Take 2 readings with the level placed diagonally in
one direction and then the other. Level the range, if
necessary, by adjusting the leveling legs and wheels.
5.
If the range cannot be level, contact a carpenter to
correct sagging or sloping floor.
Rear Leveling
Device
Use this Screw
to Adjust Rear Leveling
Device Height
LA
Leveling
Screw:
Leveling —__»
Leg
Figure 8
