30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with Sealed Top Burners)
NOTE:
1. Do not pinch the power supply cord or the flexible gas conduit between the range and the wall.
2. Do not seal the range to the side cabinets.
3. 24" (61 cm) minimum clearance between the cooktop and the bottom of the cabinet when
the bottom of wood or metal cabinet
is protected by not less than %4" (0,64
cm) flame retardant millboard covered
with not less than No. 28 MSG sheet
metal, 0,015"(0,4 mm) stainless steel,
0,024"(0,6 mm) aluminum, or 0,020"
(0,5 mm) copper.
Door Open
30" (76,2 cm) minimum clearance when
(see note 5)
the cabinet is unprotected.
4. For cutouts below 22 7/8"(58,1 cm),
appliance will slightly show out of the
cabinet.
x
e e
5. Allow at least 19 4" (48,9 cm) clearance
Sy
el
|
Go
D
for door depth when it is open.
~~,
Figure 1
Side panel
*
IMPORTANT: To avoid cooktop breakage for cutout width (E dimension) of more than
30 1/16" (76,4 cm), make sure the appliance is centered in the counter opening while
pushing into it. Raise leveling legs and the rear adjustable wheels at a higher position
than the cabinet height (see page 3), insert the appliance in the counter and then level.
Make sure the unit is supported by the leveling legs at the front and the
wheels at the back and NOT by the cooktop itself.
22 7/8" (58,1 cm) min.
23 1/4" (59,05 cm) max.
(see Note 4)
Po
pl le
1 1/8
(2,86 cm)
FRONT
OF
«——_
Fo
CABINET
,
AS HEIGHT
B. WIDTH
¢. COOKTOP
DB. DEPTH TO
E. CUTOUT. WIDTH*
F.CUTOUT
G. HEIGHT
WIDTH
FRONT. OF. RANGE
(Countertop.and
DEPTH
OF COUNTERTOP
Cabinet)
35 5/8" (90.5 cm) | 30" (76,2 cm)
31%" (80 cm)
28 5/16" (71,9 cm)
3041/16" (76,2+0,15 cm) |
21 3/4" (55,2 cm) Min.
36 5/8" (93 cm) Max.
- 36 5/8" (93 cm)
22 1/8" (56,2 cm) Max
35 3/4" (90.8 cm)
24" (61 cm) Min. with
Min.
backguard