Idiomas disponibles
Idiomas disponibles
To reach a level finish, fasten a piece of string along the
length of the hedge at the required height and use as an
alignment guide. Cut the hedge just above the string.
Pay attention that no objects such as wires are cut. The
blade or drive can be damaged.
Anti Blocking
If the blade stalls on a tough material, the load of the motor
increases. The intelligent micro-electronics senses this over-
load condition and repeatedly reverses the motor, in order
to prevent stalling and to cut the branch through.
Troubleshooting
Problem
Possible Cause
Hedgecutter does not
Battery discharged
operate
Battery not fully connected
Hedgecutter operates
Internal wiring of garden tool defective
intermittently
On/Off switch defective
Motor reverses repeatedly then stops after 3 s.
Motor runs but blades
Internal Error
remain stationary
Cutting blade hot
Cutting blade blunt
Cutting blade has dents
Too much friction, due to lack of lubricant
Blade will not move
Battery discharged
Machine defective
Excessive vibrations/
Machine defective
noise
Cutting time per bat-
Too much friction, due to lack of lubricant
tery charge too low
Blade needs cleaning
Poor cutting technique
Battery not fully charged
The blades are running
Battery discharged
slow or the anti block-
Battery stored outside of battery temperature
ing feature is not func-
tioning
Maintenance and Service
Maintenance, Cleaning and Storage
Before any work on the garden product itself (e. g.
u
maintenance, tool change, etc.) as well as during
transport and storage, remove the battery from the
garden product. There is danger of injury when uninten-
tionally actuating the On/Off switch.
For safe and proper working, always keep the product
u
clean.
Bosch Power Tools
This audible reversing cut action continues for up
to 15 rounds when the switch is actuated.
During repeated heavy cutting scenarios, the anti blocking
function could disable for 15 seconds to allow it to reset.
After cutting through, the garden product continues in its
normal mode, or in case the overload condition continues
the blades automatically stop in the open position (e.g. in
case a piece of metal fence accidentally blocks the garden
product).
Corrective Action
Recharge battery; also see "Battery Charging"
Ensure both locking levels are engaged
Contact Service Agent
Contact Service Agent
see "Working Advice" (Anti Blocking)
Contact Service Agent
Have blade sharpened
Have blade inspected/overhauled
Apply lubricant spray
Recharge battery; also see "Battery Charging"
Contact Service Agent
Contact Service Agent
Apply lubricant spray
Clean blade
see "Working Advice" (figure E)
Recharge battery; also see "Battery Charging"
Recharge battery; also see "Battery Charging"
Allow battery to warm naturally to room temperat-
ure (within battery operating temperature 0–
35 °C)
Procedure after use
The teeth of the cutting blades are very sharp. This
u
may cause cutting injuries.
Wear work gloves made of resistant material.
Cleaning the hedge trimmer
Switch off the hedge trimmer and remove the battery.
Clean the hedge trimmer with a damp cloth and apply
BOSCH lubricant spray to the blades.
Clean the areas around the front hand guard with a clean soft
cloth or brush.
English | 17
F 016 L94 563 | (18.04.2023)
