Proxxon TSG 250/E Manual página 16

7.3 Adhering or replacing the sanding
discs (Fig. 9):
Attention:
Before adhering or changing the sanding discs,
always disconnect the mains plug to prevent the
disc from starting up inadvertently. Risk of injuries!
When changing the sanding disc, we recommend
removing the sanding table together with the
housing cover. This procedure is explained in the
section „Removing and attaching the sanding
table".
Along with your disc sander, your basic equip-
ment includes two sanding discs with 80 and 240
grit each; these are easily obtainable spare parts.
The sanding disc of your TSG 250/E is covered
with an adhesive silicone film:
This material ensures the completely uncompli-
cated exchange of sanding discs because they
do not stick but adhere firmly: Firmly enough to
work, but loose enough to be easily removed later
on. Replacing the discs is thus no problem, either
because of wear or because you need discs with
different grits while working.
1. We recommend removing the sanding table
together with the housing cover. This procedure
is explained in the section „Removing and
attaching the sanding table".
2. To change the disc, simply pull it off from the
plate.
3. Peel off the rear protective film of the new disc.
4. Press the disc on to the sanding disc evenly
and bubble-free.
5. If necessary, reassemble the sanding table with
housing cover as explained in the section
„Removing and attaching the sanding table".
Attention:
Two storage discs of silicone film are also
included in the scope of delivery. If you remove a
sanding disc but want to use it again, please
cover the adhesive surface with the film for stor-
age.
- 16 -
Note:
8 Accessories:
Self-adhesive white corundum sanding discs
for TSG 250/E (Ø 250 mm)
Industrial quality. For sanding soft and hard
woods, chipboards, fibre boards, non-ferrous
metals, steel, plastic, cork, rubber and minerals.
Article number 28 970 80 grit
Article number 28 972 150 grit
Article number 28 974 240 grit
Self-adhesive silicon carbide sanding discs for
TSG 250/E (Ø 250 mm)
For sanding non-ferrous metals, steel, glass, GRP,
plastic and ceramics.
Article number 28 976, 320 grit, Contents: 5
pieces
9 Care and maintenance
Attention:
Always disconnect the mains plug before any
cleaning, adjusting, maintenance or repair!
The machine is primarily maintenance free. For a
long service life, clean the device after every use
with a soft cloth, hand brush or brush. A vacuum
cleaner can also be recommended. The vacuum
cleaner should always be used in general!
The external surface of the housing can be
cleaned using a soft, possibly moist cloth. Mild
soap or other suitable cleansers may be used as
well. Do not use solvents or alcohol-based
cleansers (e.g. benzene, cleaning alcohols, etc)
as these could attack the plastic housing casings.
10 Disposal
Do not dispose of the device in the household
waste! The device contains valuable substances
which could be recycled. If you have questions
concerning this topic, please address your munic-
ipal disposal company or other appropriate
municipal institutions.
(5 pieces)
(5 pieces)
(5 pieces)
Note: