Proxxon TSG 250/E Manual página 14

• Stop operation of the tool immediately if exces-
sive vibration occurs!
• Unsuitable bits and cutters can cause exces-
sive vibration and noises. Only use suitable bits
and cutters!
• Take breaks if necessary when working with the
device!
Use only in closed rooms!
Do not dispose of the electrical device
in the household waste!
6 Commissioning the device
6.1 Setting up your disc sander:
When setting up the device, always make sure
you have a level and firm surface! Secure stability
is indispensable for working with the device!
When setting up and fixing the device, always dis-
connect the mains plug to prevent the disc from
starting up inadvertently. Risk of injuries!
1. Remove the disc sander from the packaging
and check if the scope of delivery is complete.
2. Fasten the device with the fastening screws to
a sturdy workbench or worktop (see Fig. 2) as
per the master gauge for holes in Fig. 2a.
6.2 Removing and attaching the sanding
table (Fig. 3):
Attention:
Before removing and inserting the sanding table,
always disconnect the mains plug to prevent the
disc from starting up inadvertently. Risk of injuries!
Your TSG 250/E is normally operated with the
attached sanding table (as in delivery condition).
But it is also possible to remove the sanding table
if required for certain work tasks or when chang-
ing the sanding discs.
1. Unscrew Allen screws 1
2. Take off sanding table 2 together with the hous-
ing cover 3
- 14 -
Note:
Note:
3. To attach, simply insert the sanding table
together with the housing cover back in the
normal position
4. Screw Allen screws 1 back in and tighten.
6.3 Check and set angle display (Fig. 4):
Attention:
Before doing any adjusting work, always discon-
nect the mains plug to prevent the disc from start-
ing up inadvertently. Risk of injuries!
The angle display is set accurately by the factory.
The angle stop can be easily readjusted, should
this ever be necessary:
1. Release both clamping screws 1
2. Align work table 2 with an angle to exactly 90°
as shown in Fig. 4
3. Retighten clamping screws 1
4. Release screw 3 slightly and correct the „zero"
position of indicator 4 as necessary.
5. Re-tighten screw 3
6.4 Setting the sanding table angle
(Fig. 5):
Attention:
Before setting the sanding table, always discon-
nect the mains plug to prevent the disc from start-
ing up inadvertently. Risk of injuries!
To chamfer boards or slats, for example, we re -
commend placing these objects on the pivoted
table. Also refer to Fig. 5a. Set the chamfer angle
as follows:
1. Release the right and left clamping screws 1
(Fig. 5)
2. Swivel sanding table 2 to the required angle
position and check the set value on angle scale
3.
3. Retighten clamping screws 1.