Idiomas disponibles
Idiomas disponibles
A clearly laid out table at the rear of the device
makes it easy to pre-select the rotational speed
or sanding speed for the appropriate material.
The high-quality aluminium sanding table can be
adjusted to tilt up by 10° and down by 50°. A scale
makes it easy to read the angle. This also contains
the guide groove of the angle stop that is also
included in the delivery.
It is even possible to accurately refinish small
turning steels, sharpen chisels and knives, re-
sand screwdriver edges, etc. ...
Delivery includes two sanding discs of 80 and 240
grit each. A silicone film was attached to the
sanding disc to guarantee best sanding disc
exchange (e.g. while working with different grits).
A suction connection for the vacuum cleaner
makes sure that sanding dust has no other place
to go but in the vacuum cleaner. This presents
the best equipment for any occurring sanding
work.
3 Scope of delivery:
1 pc. Disc sander TSG 250/E
1 pc. Angle stop
1 pc. Rubber connecting piece for vacuum
cleaner connection
2 pc. Sanding discs 80 grit
2 pc. Sanding discs 240 grit
2 pc. Storage discs
1 pc. Operating instructions
1 pc. Brochure with safety regulations
1 pc. Device packaging
4 Legend (Fig. 1)
1. Speed controller
2. On/Off switch
3. Sanding table
4. Clamping screw angle stop
5. Angle stop
6. Scale angle stop
7. Housing
8. Mains cable
9. Connecting piece for vacuum cleaner
10. Clamping screw of angle adjustment
11. Scale of angle adjustment
12. Indicator
13. Protecting cover
14. Sanding disc
5 Technical data
Sanding speed:
Sanding disc:
Table adjustment:
Noise level:
Vibration:
Work table:
Overall size (without table)
(L x D x H):
Motor:
Voltage:
Short-term operation
Noise/vibration information
The information on vibration and noise emission
has been determined in compliance with the pre-
scribed standardised and normative measuring
methods and can be used to compare electrical
devices and tools with each other.
These values also allow a preliminary evaluation
of the loads caused by vibration and noise emis-
sions.
Warning!
Depending on the operating conditions while
operating the device, the actually occurring emis-
sions could differ from the values specified above!
Please bear in mind that the vibration and noise
emission can deviate from the values given in
these instructions, depending on the conditions
of use of the tool. Poorly maintained tools, inap-
propriate working methods, different work pieces,
too high a feed or unsuitable work pieces or mate-
rials or unsuitable bits and cutters (here: saw
blade) can significantly increase the vibration load
and noise emission across the entire work period.
To more accurately estimate the actual vibration
and noise load, also take the times into consider-
ation where the device is switched off, or is run-
ning but is not actually in use. This can clearly
reduce the vibration and noise load across the
entire work period.
Warning:
• Ensure regular and proper maintenance of your
tool
250 – 750 m/min
Ø 250 mm
tilts 10° up, 50° down
72 dB(A)
<= 2.5 m/s²
275 x 105 mm
270 x 280 x 330 mm
230 V, 50/60 Hz
SO 15 min
- 13 -
