LEGRAND KEOR SPE TOWER Manual De Instalación Y Del Usuario página 47

4.6 Setup mode
It is possible to change some parameters of the UPS while the UPS is in standby or in normal mode.
Press and hold the
shown.
Use the button to enter the parameter to be changed. As confirmation, the value on the digits
will start to flash. Press the
use and buttons to change the values of the parameter and confirm the value with the
button. As confirmation, there is one beep and the value on the digits stop to flash.
To exit the setup mode, press and hold the
1 minute the UPS exits from the setup mode.
The following tables indicate the parameters that can be set in standby mode and in normal mode.
FUNCTION
SET +
EPO/roo
SET + OUT + V
SET + IN + OUT
button for 3 seconds until there is one beep is heard and the SET icon is
button to exit from the parameter. While the selected value flashes,
STANDBY MODE
Setting for the EPO auxiliary contact.
EPO: Emergency auxiliary contact to turn off the UPS in case of emer-
Possible values: 200/208/220/230/240 V
button for 3 seconds. If no button is pressed, after
DESCRIPTION
Buzzer
Possible values: on / oFF
Default: on
Main page
gency
roo: UPS remote turn on/off
Subpage
nC: contact normally closed
nO: contact normally opened
Output voltage
Default: 230V
Auto Restart function
Possible values: on / oFF
Default: on
KEOR SPE TOWER
47