Idiomas disponibles
Idiomas disponibles
• These statements are only valid for rechargeable
batteries and primary batteries sold in the countries
of the European Union and subject to the Europe-
an Directive 2006/66/EC. In countries outside the
European Union, different regulations may apply to
the disposal of rechargeable batteries and primary
batteries.
15. Troubleshooting
WARNING
Always switch the machine off and remove the mains plug prior to all maintenance and cleaning work.
Fault
Saw blade without pins
loosens after switching
off the engine
Motor does not start
Saw blades brake
Saw blade oscillates,
not aligned straightly.
Possible cause
Saw blade clamping screw of the
tool receiver (27) not tightened
enough
Extension cable defective
Connection to the motor or switch
not OK
Motor or switch faulty
Tension set incorrectly
Load too high
Incorrect saw blade type
Workpiece not fed straightly
Holders not aligned
www.scheppach.com
Remedy
Tighten the saw blade clamping screw of the
tool receiver (27)
Replace the extension cable
Have this checked by an electrician
Have this checked by an electrician
Set correct tension
Feed workpiece more slowly
Use correct saw blades
Avoid lateral pressure
Open the screws that fasten the holders.
Bring the holders into the vertical position
and tighten the screws again.
GB | 41
