Idiomas disponibles
Idiomas disponibles
AC motor
• The mains voltage must be 220-240 V~.
• Extension cables up to 25 m long must have a
cross-section of 1.5 square millimetres.
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Data of machine type plate
Connection type Y
If the mains connection cable of this device is dam-
aged, it must be replaced by the manufacturer, their
service department or a similarly qualified person to
avoid dangers.
11. Transport
• Transport the electric tool by lifting it by the machine
housing (36). (Fig. 26)
• Never use the protective devices for handling or
transport.
• Make sure that the exposed part of the saw blade
is covered during transport, e.g. by the protective
device.
12. Cleaning, maintenance and
ordering spare parts
WARNING
Always switch the machine off and remove the mains plug
prior to all maintenance and cleaning work.
12.1 Cleaning
Keep protective devices, air vents and the motor hous-
ing as free of dust and dirt as possible. We recommend
cleaning the device directly after every use.
12.1.1 Exterior cleaning
• Clean the device at regular intervals using a damp
cloth and a little soft soap.
• Do not use cleaning agents or solvents. These could
damage the plastic parts of the device.
• Make sure that no water can penetrate the device
interior.
12.1.2 Interior cleaning (fig. 15)
1.
Remove the screw (33).
2.
Loosen the screw (32).
3.
Remove the cover (7).
4.
Blow out the device interior with low-pressure
compressed air.
5.
Attach the cover again (7).
6.
Fasten the screw (32).
7.
Insert the screw (33) again and tighten it.
12.2 Maintenance
12.2.1 Bearings (Fig. 1)
• Lubricate the bearings (9) of the deflection rollers
after approx. 50 operating hours at the latest using
high-quality machine grease.
The device has no further internal parts that require
maintenance.
12.2.2 Carbon brushes
If excessive sparks are generated, have an electrician
check the carbon brushes.
ATTENTION
The carbon brushes must only be replaced by an elec-
trician.
12.2.3 Mains cable
If the mains cable is pulled out, cut, or damaged in
some other form, then it should be replaced immedi-
ately. Do no lubricate the bearings of the motor and
internal parts!
12.3 Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consumables.
Wearing parts*: Carbon brushes, saw blade, table inlay
* May not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
12.4 Ordering spare parts
Please provide the following information when ordering
replacement parts (via the service-hotline):
• Device type
• Device article number (see packaging or instruction
manual)
www.scheppach.com
GB | 39
