Würth ISS 30-L CLASSIC Traducción Del Manual De Instrucciones De Servicio Original página 26

Telescope tube
Floor brush
Round brush
Small nozzle
Manuals
Main Components
no name
1 floor brush
2 telescope tube
3 hose connector
4 hose
5 upper suction
6 handle
7 switch
Maintenance
In order to lengthen the life time, single using time
■
is better not more than 20 minutes
In order to lengthen the life time, clean the body,
■
filter and dustbag after use.
26
1
1
1
1
1
no name
8 front suction
9 pushing rod
10 cable
11 clamps
12 tank
13 small nozzle
14 round nozzle
Twine the power cord well, put accessories in slot
■
Clean the dirty water after using to prevent the
■
rusting or corrosion of barrel.
■ Clean the surface of vacuum cleaner with dry
cloth to prevent water into vacuum 0 cleaner
caused short circuit even vacuum cleaner burning.
Common Fault Guides
Fault Possible reason
Motor 1. Check power plug if it is wired
failure up properly?
2. Check power socket if it is
electricity?
3. Check the switch if it is turned
on
Suc- 1. Check brush, hose and tele-
tion scopic tube if they are blocked?
abate 2. Check dustbag if it is with full
dust?
3. Check the filter if it is blocked
Hot 1. Check the suction if it is normal
air 2. Check the using time if it is more
outlet than 20 minutes
Environmental Protection
Recycle raw materials instead of disposing as
waste. Machine, accessories and packaging
should be sorted for environment - friendly
recycling.
The plastic components are labeled for categorized
recycling.
Only for EU countries:
Do not dispose of power tools into household waste!
According to the European Guide Lines 2012/19/
EC for waste electric and electronic equipment and its
implementation into national law, power tools that are
no longer usable must be collected separately and
recycled in an environmentally friendly manner.
Würth will gladly take back your defective Würth
power tool free of charge.
Handling method
1. Reput the plug into
the socket
2. Make sure the
power socket is
electricity
3. Turn on the switch
1. Clean the blockages
2. Clean the dustbag
3. Clean the filter
1. The hot air from
vacuum cleaner is
caused by motor
heat conducting. It's
common , please
continue to use.
2. Please turn off to
rest 20 minute
before use again.