•
Remove the food from the freezer. Store them in a cool place, well
covered.
•
Switch the appliance off and remove the plug from the power
supply, or switch off or turn out the circuit breaker or fuse.
•
Clean the appliance and the interior accessories with a cloth and
lukewarm water. After cleaning wipe with fresh water and rub dry.
•
After everything is dry place appliance back into service.
Replace the lamp
The internal light is a LED lamp. To replace the lamp, contact the Customer
Support Service.
2.4. Troubleshooting
Caution! Before troubleshooting, disconnect the power supply. Only the
Customer Support Service or a competent person must do the
troubleshooting that is not in this manual. Important! There are some sounds
during normal use (compressor, refrigerant circulation).
Problem
Appliance does not work
Appliance freezes or
cools too much
The food is not frozen
enough.
30
Possible cause
Power plug is not plugged in or is
loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold or the
appliance runs on Super mode.
Temperature
is
not
properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
The appliance is near a heat source.
Solution
Insert power plug.
Check fuse, replace if necessary.
Power plug malfunctions are to be
corrected by the Customer Support
Service.
Turn the temperature regulator to a
warmer setting temporarily.
Refer to the initial Temperature Setting
section.
Open the door only as long as necessary.
Turn the temperature regulation to a
colder setting temporarily.
Refer to the Installation section.