Hitachi DS 12DVF3 Manual De Instrucciones página 15

Ocultar thumbs Ver también para DS 12DVF3:
Idiomas disponibles

Idiomas disponibles

1. Insert the plug of battery charger into the receptacle.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as
shown in Fig. 4. Make sure it contacts the
bottom of the battery charger.
3. Charging
When the battery is connected to the battery charger, charging will commence and the
pilot lamp will light on.
NOTE: If the pilot lamp dose not light, pull out the plug from the receptacle and check
if the battery is properly mounted.
In approx. 30 – 50 min., when the battery is fully charged, the pilot lamp will go out.
NOTE: The battery charging time becomes longer when a temperature is low or the
voltage of the power source is too low.
When the pilot lamp does not go off even if more than four hour has passed after
start of the charging, stop the charging and contact your HITACHI AUTHORIZED
SERVICE CENTER.
4. Disconnect battery charger from the receptacle.
CAUTION:
Do not pull the plug out of the receptacle by pulling on the cord.
Make sure to grasp the plug when removing from receptacle to avoid damaging cord.
WARNING:
Do not use the electrical cord if damaged. Have it
repaired immediately.
Battery
(EB1214S) Battery
(EB1414S)
Fig. 4
English
Battery
(EB1814SL
or EB1820L)
Pilot
Lamp
15
loading

Este manual también es adecuado para:

Ds 14dvf3Ds 18dvf3