Idiomas disponibles
Idiomas disponibles
Connections
Basic instrument has two rear connectors CN1 and CN2. If 2RE
output option card is installed, two more connectors CN3 and
CN4 appear. See all four connectors location and their pin out in
the right figure.
Terminals for CN2 connector admit cables with section from
0.2mm² up to 1.5mm² (AWG 24÷14).
Terminals for CN1, CN3 and CN4 connectors admit cables with
section from 0.08mm² up to 2.5mm² (AWG 28÷12).
To perform wiring connections, strip the cable leaving from 7 to
10mm exposed to air, insert it in the proper terminal while
pushing down the key insertion tool to open the clip inside the
connector. Release the key tool to fix wire to the terminal.
Proceed in the same way for the rest of terminals. Once all
connections are done, plug connectors to the instrument.
CN4 (relay 2)
CN3 (relay 1)
4
NO
1
5
CM
2
3
6
NC
Notes:
NO: Normally open contact.
CM: Common contact.
NC: Normally closed contact.
* Polarity in CN1 is indistinct for DC power.
Process input signal wiring diagrams (V)
4 WIRES CONNECTION WITH EXTERNAL EXCITATION
INDICATOR
1
7
+V
COM.
3 WIRES CONNECTION WITH EXTERNAL EXCITATION
INDICATOR
1
7
+V
COM.
SERIE KOSMOS
CN1*
NO
1
Phase (AC)
CM
2
Neutral (AC)
NC
TRANSDUCER
0-10V
0-200V
+OUT -OUT -EXC. +EXC.
-
+
EXC.
TRANSDUCER
0-10V
0-200V
+OUT -OUT
+EXC.
-
+
EXC.
www.ditel.es
JR-P / JR20-P
CN4
4
5
6
CN1
1
Key tool for cable insertion.
1
COMMON / Pt100 (B) / Pt1000 / -TC / Pot. Term. 1
2
Pt100 (A) / Pt1000 / +TC / IN 1k-10k / Pot. Cursor
3
4
5
6
7
4 WIRES CONNECTION WITH EXCITATION SUPPLIED BY THE INDICATOR
INDICATOR
1
7
6
+V
+EXC.
COM.
3 WIRES CONNECTION WITH EXCITATION SUPPLIED BY THE INDICATOR
INDICATOR
1
6
7
+V
+EXC.
COM.
Rear connectors location.
CN3
1
2
3
CN2
2
CN2
IN 50k / Pot. Term. 2
Pt100 (B)
+mA
+EXC. 24V
+V
TRANSDUCER
0-10V
0-200V
+OUT -OUT -EXC. +EXC.
TRANSDUCER
0-10V
0-200V
+OUT -OUT
+EXC.
53
