Idiomas disponibles
Idiomas disponibles
Device description
All information contained in this manual, unless indicated, is valid for both JR-P and JR20-P models.
JR-P and JR20-P models from KOSMOS serie are universal digital indicators fully configurables that allow input
type selection in order to be used as needed. Available signal inputs are the following:
PROCESS (V, mA)
THERMOCOUPLE (J, K, T y N)
Pt100 and Pt1000 SENSOR
POTENTIOMETER
RESISTANCE
The basic instrument consists of a soldered assembly composed of a main board, a display and an input signal
circuits. It can also be incorporated, as an option, an extra plug-in 2 SPDT 8A relays circuit output which is isolated
from signal input and power supply. This extra circuit has independent connectors that are located on the rear part
of the instrument once it is installed.
Specially designed for the control of industrial processes and monitoring input variables, both models have 4 digits,
configurable decimal point and 2 LEDs for setpoints status indication, they are easy to scale into desired
engineering units, directly by frontal keys or rear input signal value in teach mode. They also provide a 24V DC
output for sensor excitation.
JR-P model is provided with 14mm-high digits and maximum display range of -9999 to 9999 whereas JR20-P
has 20mm-high digits and a maximum range of -1999 to 9999. JR20-P has a larger display to provide a better
reading at longer distance, although minus LED sign is integrated in the most significative digit instead of being
external, as in JR-P model.
Both devices have three frontal keys to interact with internal software and set configuration in order to adapt their
function to particular applications. Device programming runs through some independent menus that show short
messages to easily identify input type and/or display configuration steps.
If relays output option card is installed, once it is recognised by the instrument, activates its own configuration
menu which is only visible under this conditions.
Dimensions and mounting
SERIE KOSMOS
Press slightly to fasten the clips to the latching slots
on the case and get the unit fully assembled and
close fitted to achieve a good sealing.
To remove the instrument from the panel, pull outwards the rear fixing
clips latching tabs until they are disengaged, then slide fixing clips back
over the case.
www.ditel.es
JR-P / JR20-P
To install the
instrument, prepare
92x45mm panel cut-out and slide the unit
inwards making sure of placing the sealing
gasket between the front side panel and
the frontal bezel.
While holding the unit in place, put the
fixing clips on both sides of the case and
slide them through the guide tracks until
they reach the panel at the rear side.
a
51
