Idiomas disponibles
Idiomas disponibles
Installation
To physically install the output option, the electronics assembly should be first lifted out from the case. Use a
screwdriver or similar to slightly press both side tabs until the rear case is released. Then broke the junctions from
the corresponding polycarbonate cover in order to obtain the required orifice in the case. This orifice will allow 2RE
connectors come out through instrument rear part once it is installed.
Install 2RE option on the indicated location pushing slightly down until both connectors get perfectly together. For
best installation, it is recommended to solder this card to the main circuit making use of the copper pads on both
sides of its insertion pin and those surrounding the circuit hole where it is inserted in.
Once 2RE is installed, carefully put the circuitry again inside the case verifying that circuits slide properly without
much effort through rear case internal guides.
Each output card is supplied with an adhesive label that indicates wiring connections. To help identifying terminals,
this label should be placed in the upper side of the unit case. Besides its own connections, there are other output
options indications.
To lift out electronics
assembly
from
the
case,
slightly
press
both side tabs until
rear case is released.
When rear case is completely released, junctions
must be broken to remove this polycarbonate cover
to allow 2RE option connectors come out.
SERIE KOSMOS
Front panel cover
Fix here
connections label
Once 2RE is installed and instrument is again
inside the case, 2RE connectors should come out
through the obtained orifice as this figure shows.
www.ditel.es
JR-P / JR20-P
Install 2RE card by plugging
connector in the main circuit.
Input circuit.
Display circuit.
Main circuit
67
