Idiomas disponibles
Idiomas disponibles
INPUT CONFIGURATION
Configuration menu
When connecting instrument to Power supply, display test begins automatically to check the good function of LEDs
and digits, once this test is finished, display shows internal software version and then the unit goes to RUN mode.
Configuration software has a hierarchical structure composed of a number of menus and submenus. By pressing
ENTER key, display shows "Pro", a new pressing brings access to main menu where appear configuration menus,
that is, input configuration (InP), display configuration (dSP) and setpoints configuration (SEtP). This last menu
only appears if 2RE output option card is installed.
If configuration is totally locked-out, when pressing ENTER key to get into main menu, display shows "dAtA"
instead of "Pro". This indicates that it is only possible to see programmed information and that it is not allowed to
modifiy any parameter from the entire configuration. In this visualization mode, the instrument automatically
switches back to RUN mode after 15 seconds since last key press.
8 8 8 8
Pro
dAtA
InP
dSP
Once inside each menu, all configuration parameters are sequentially shown and they can then be introduced or
edited by pressing ENTER key. Numeric values must be entered digit by digit, first selecting digit and then
changing its value. When the display reach desired value, a new ENTER key pressing validates data and routine
goes forward to next configuration step.
Data entered or changes made during configuration are stored in device memory only when programmation
routine belonging to the respective submenu is completed, not before. On last routine step and after having
pressed ENTER key, display indicates "StorE" and the unit goes back again to RUN mode.
Input configuration
The first menu corresponds to input configuration. This, in turn, consists of four submenus, one for each input
type: process (ProC), temperature (tEMP), potentiometer (Pot) and resistance (rES).
SERIE KOSMOS
The instrument provides 3 keys for progressing through the
MAIN MENU
menus and submenus and for data introducing/modifying:
SEt
InP
ProC
tEMP
www.ditel.es
JR-P / JR20-P
ENTER: Vertical displacement / Validates data.
UP: Increases active digit value.
SHIFT: Horizontal displacement / Changes active digit.
Pot
rES
56
