Emptying The Boiler; Troubleshooting - Ferroli AQUA1 PLUS 90 HT Manual De Instalación Y Mantenimiento

deposits in the condensate drain pipe.
These little precautions ensure the total efficiency
of the product with a consequent energy saving.
Mg Anode
Anode gasket
¾"
Fig. 3 – Removal of the anode
7.3

Emptying the boiler

It is advisable to drain the water from inside the
boiler if the boiler is idle for a certain period of time,
especially in low temperatures.
It is sufficient to disconnect the water supply input
connection (see paragraph 5).
N.B.: It is important to empty the system
in case of low temperatures in order to
avoid the water freezing.
If the product is not being used for a long
period, beside empting the boiler it is
advisable to unplug the socket since the
equipment is provided with an anti-frost
function that could start uselessly, even if
the boiler is empty.
8

TROUBLESHOOTING

In case of problems of equipment performance,
without the occurrence of any of the alarms or
errors described in the relative paragraphs, it is
advisable to check if the problem can be easily
solved by checking the possible solutions specified
in the table below prior to seeking technical
assistance.
Problem
The heat pump does
not work
The compressor and/or
the fan do not work
The heat pump
continuously switches
itself on and off
The heat pump remains
continuously switched
on and does not switch
off
The electric heating
element does not
switch on
WARNING!
operator does not succeed in solving
the problem, switch off the equipment and seek
specifying
purchased.
Possible causes
There is no electricity;
The plug is not correctly
inserted in the socket.
The set safety period of
time has not finished;
The scheduled
temperature has been
reached.
Wrong programming of
the
parameters/setpoint
and/or hysteresis
values.
Wrong programming of
the parameters/set
point and/or hysteresis
values.
Your intervention is not
required
In the event that
technical assistance
the device model
the