OTo
install bagger components
to tractor
1
1,
Discharge Chute
2, 3/8 Nut
3.
Flat Washer
Removedischargechutefrom
rear oftractor.
Unhook
the
two (2) straps
and pull chute
out and away
from tractor.
Remove
the two (2) 3/8 nuts and flat washers
from the
bolts at the tractor
back plate.
3
1.
Support
Bracket
2.
Clevis
Pin 10 x 17mm
1
3.
3/8 Lock Nut
,5
4.
3/8 x 63,5mm
Hex Bolt
5.
10,3mm
(13/32")
flat
washer
6.
Retainer
Spring
Install the two upper support
brackets
through
the back
plate and to the
chassis,
install the clevis
pin 10xl 7mm
and secure
with retainer
spring.
Assemble
both
support
brackets
to the outside
of the
bagger
support
tube
using two each 3/8 x 63,5mm
hex
bolts13/32"
I.D. flat washers
and 3/8 Iocknuts
from parts
bag. Tighten
securely.
1,
2.
3.
3/8 Lock nut
Flat Washer
Support Tube
Using
the nuts
and flat washers
removed
from
tractor
back plate,
install
the bagger
support
tube
to the back
plate as shown.
Tighten
securely.
1.
Hook
2.
Discharge
Chute
3.
Back plate slot
3
Replace
discharge
chute
into
rear
opening
of tractor.
Secure
the chute
with the two hook straps.
NOTE:
The strap
hook must go through
the discharge
chute
only. Do not allow
the hook to enter
the slot in the tractor
back plate. This will allow the discharge
chute to float with the
mower
deck when moving
on uneven
terrain.
23
