Idiomas disponibles
Idiomas disponibles
English
16
Assembling the breast pump
Make sure you have cleaned and disinfected the parts of the breast pump that come into contact with milk.
Warning: Be careful, when you have disinfected the breast pump parts by boiling
them, they can be very hot. To prevent burns, only start assembling the breast pump
when disinfected parts have cooled down.
Warning: Wash your hands thoroughly with soap and water before you touch breast
pump parts and breasts to prevent contamination. Avoid touching the inside of
containers or lids.
Caution: Before each use, visually inspect the individual components for cracks, chips, tears,
discoloration or deterioration. In the event that damage to the device is observed, discontinue use
until the parts have been replaced.
Caution: Inspect the tubing. If you find condensation in the air tube, wash and dry it immediately
or replace the tubing. If you see breast milk inside the tubing or tubing connector, do not attempt to
wash, clean or disinfect the tubing or tubing connector. Instead, contact the manufacturer.
Note: Correct placement of the flange, silicone diaphragm and silicone tube is essential for the breast
pump to form a proper vacuum.
1. Wash your hands
thoroughly with soap
and water.
5. Place the silicone
diaphragm in the pump
body.
2. Push the white valve in
the pump body as far as
possible.
6. Make sure that the
silicone diaphragm fits
securely around the rim
by pressing it down with
your thumbs.
3. Screw the pump body
onto the bottle.
7. Attach the silicone
tube and cap onto the
diaphragm. Push down
the cap until it is securely
in place.
4. Screw the flange onto
the pump body.
8. Connect the tube(s)
to the motor unit.
